No, Intellikey has not control over your engine onl;y the start circuit.

Yes, Intellikey is designed to allow start in the event of a failure. You will also be supplied with a removal adapter that can be installed if you have to remove the Intellikey unit for repair.

Keys must be purchased from Midwest Panel Builders, once purchased you will be provided a key and a file to upload to your intellikey module.

In the app select “Intellikey Settings” then scroll down and select “Pin Options” thern “Reset Pin”. You will be given a challenge code, contact Midwest Panel Builders support with the challenge and once you are verified as the owner you will be provided with a reset code. This will reset your pin to 7600, you can then change the pin by selecting “Change Pin” from ther “Pin Options” menu.

Currently only the G3X is supported.

Audio is captured by activating audio in the settings.  You will need to connect the audio lead to the pilot headest wires. If on a mono system, hook directly to the headphone phone wire, if stereo use supplied 300ohm resistors to tie audio wire to right and left audio channels.

If RPM monitoring is off the lights will time out after 5 minutes, if connected to a supported EFIS for data logging and RPM monitoring is on they will turn off above 600rpm.

Intellikey is designed to monitor voltage, if the voltage drops below the set parameter, Intellikey will shut itself down to save battery life. Once the master is turned on, Intellikey will re-activate.

1. The key fob is not within range.
2. The key fob is not turned on, press the button on ther fob to see if the blue light comes on, if not press and hold to turn on the key
3. Check key fob battery.
4. Go to “Inyellikey Settings” and then “Intellikey Mode” to be sure aurshow mode is not activated.
5. Try to activate with bypass pin.